I have data captured with a 6404D, such as attached. I am trying to count the number of pulses of height above the +ve ruler setting (20mV) and, separately, below the -ve ruler setting (-20mV). However, every combination of measurement settings I have tried returns zero, including rising and falling edge and various smaller windows.
Any help would be appreciated.
Thanks,
Richard Sharp
You could save the current waveform rather than the whole set, which may reduce the file size. Otherwise put the file on a file server and send a link to support@picotech.com
If you do a low pass filter of 20kHz then you even can go to -3 mV
but you wont get the positive only pulses.
And if possible set the sensitivity to +/- 100 mV
for the counting pulses the overvoltage is no problem in your data the 8bit ADC noise is a far bigger problem.
P.S. if you export the data to CSV and do the filtering in code (python / C++ / basic) then you can count the number of times the difference over a period of 25uS is bigger than 10mV (or even 5mV)
P.P.S. a math channel with LowPass(A-A[0,000025];20000) will do nice.