Post your MATLAB discussions here
- Posts: 0
- Joined: Tue Sep 19, 2023 1:34 pm
I was trying to connect my Picoscope 6426E to MATLAB, following the tutorial on YouTube. I installed the drivers, and the Add-ons of MATLAB (Instrument Control and PicoScope Support). However, when I run the example, this error appears:
Warning: No units found.
Opening PicoScope 6000 Series device...
Error using icdevice/connect
An error occurred while executing the driver connect code.
No unit found, please check connections.
Any ideas? Thanks!
- PICO STAFF
- Posts: 258
- Joined: Tue Jul 18, 2017 8:28 am
The 6000E devices use the ps6000a driver so need to use the corresponding set of examples rather than the ps6000 driver and examples.
Technical Support Engineer