Hello
I am programming a GUI in Appdesigner/Matlab for a5444D model.
If I run an example script(PS5000A_ID_Example), it works perfect.
Now I want to use the script as function whose parameter-values are given by the GUI through a callback function if a button is pressed.
I added the following switch-case statement to the function for the channel selection.
switch ch
case 0
[status.setChA] = invoke(ps5000aDeviceObj, 'ps5000aSetChannel', ch, 1, type, range, analog_offset);
case 1
[status.setChB] = invoke(ps5000aDeviceObj, 'ps5000aSetChannel', ch, 1, type, range, analog_offset);
case 2
[status.setChC] = invoke(ps5000aDeviceObj, 'ps5000aSetChannel', ch, 1, type, range, analog_offset);
case 3
[status.setChD] = invoke(ps5000aDeviceObj, 'ps5000aSetChannel', ch, 1, type, range, analog_offset);
end
If I run the app I always get the error message in the chosen case:
Error using icdevice/invoke
ps5000aSetChannel:status code 80,please refer to the Picostatus.m file
and sometimes:
parametres must be scalars.
I checked the variables with the assignin method to show them in the workspace and they were scalars. The status code 80 says invalid analogue offset , but which values are valid?
I would be really grateful for any kind of help.
Error using icdevice/invoke
Re: Error using icdevice/invoke
Hi
There isn't enough information in the post as to why you're getting the error, would you be able to either post your .m file here or email it into support@picotech.com so that I can look at the full setup please?
Neil
There isn't enough information in the post as to why you're getting the error, would you be able to either post your .m file here or email it into support@picotech.com so that I can look at the full setup please?
Neil
Neil
Technical Support Engineer
Technical Support Engineer