0.05degC end to end accuracy

Which product is right for your exact requirements
Post Reply
pohchinpoh
Newbie
Posts: 1
Joined: Fri Oct 15, 2021 12:17 pm

0.05degC end to end accuracy

Post by pohchinpoh »

Hi,
I'm interested to use PT100 with the 4 channel pico. Is it possible to enter the cvd coefficient from the calibration certificate?
The typical measurement range is within 0 to 40degC.
Is it possible to output the measured values thru Modbus RS485 or Modbus TCP?

I have a project that I need 8 measurements with +/-0.05 degC accuracy.
The typical calibration uncertainty is 0.03degC with CVD coefficients, I saw the datasheet that the pico unit could measure PT100 with 0.01degC accuracy. I need the measurements in my PLC via Modbus if possible.
Thanks

Post Reply