Hi.
I have a problem trying to trigger my signal in order to see it clearly. My target is to measure a periodic signal of hundreds of microseconds. I have used the program ps3000_runStream and changed all constants to control. But the point is that some of them doesn't work properly and I am a begginner with LabView. I have tried using Picoscope 6 and all works, but I need to have the same in LabView because I am going to add some components to measure at the same time. My program is attached to this message.
Thanks
Well, the trigger controls don't work at all, neither do the ETS ones. The channel controls do something but not what they should. For instance, when ENABLED is activated or deactivated the only difference is a change in the amplitude, but the channel is still being displayed. I downloaded the SDK this month and it is the version 10.5.2.
When using the LabVIEW example I was able to get the trigger to work as expected.
Please note when the trigger is not enabled it will store data as fast as soon as it can.
While when the trigger is enabled then only when the trigger event occurs will it store data.