I have battery terminals connected directly to the positive and negative terminals of Electronic Load. But, I have no idea how can I connect the ADC 20 as well as terminal board to the Electronic Load to measure the discharge voltage and current.
This is a different question than the other thread but I got the same reply from you.
Dear Sir/Madam,
I am doing Lithium ion cell discharge test, I want to use ADC 20 as well as terminal board for voltage, current and temperature measurement.
The battery is going to discharge through microprocessor controlled loads or programmable DC Electronic Load instead of using resistor. (I use this EL9000 http://www.elektroautomatik.de/en/produ ... l9000.html)
I have battery terminals connected directly to the positive and negative terminals of Electronic Load. But, I have no idea how can I connect the ADC 20 as well as terminal board to the Electronic Load to measure the discharge voltage and current.
I would like to check with you if ADC-20 and terminal boards can be used along with any programmable electronic load? If yes, what are the? What I can see is from the device (please see attached file), there are only two terminals where I can connect to a DC source (in this case a battery), so I have no idea how could I connect ADC-20 to the programmable electronic load.
Thanks
Last edited by want2know on Wed Sep 11, 2013 12:21 pm, edited 1 time in total.