Hi! Im running Matlab 2016b and a picoscope 5444B. i installed the driver, and running the simple "get block data" example seems to work fine. However, channel setup commands seem to have no effect in my script. i want to run just 2 channels, in 15bit + signal generator. to set up the channels i use:
However, the value returned in "resultion" is always 14 bits, cant seem to set it higher (i can set it lower. 12 and 8 bit modes work fine).
The signal generator works fine, as far as i can tell.
What is the correct way to set up the channels pre-capture in matlab?
Rather than passing the enumeration by name, please use the ps5000aEnuminfo struct that is loaded into the base workspace when the PS5000aConfig.m file is run to access the enumeration values.
Hi Hitesh, sorry for the rather late reply. Thanks, using the enums worked, rather than calling them by name. i am getting another problem however. When trying to run the AWG examples, i am getting a "method not found" error when trying to run the sections using either the "setSigGenArbitrarySimple" or "setSigGenArbitrary" methods. anything using "setSigGenBuiltInSimple" or anything else works. feels like its specifically the methods relating to the AWG. i am using the 5444B with AWG, so it should work....