Test and Measurement Forum

Conductivity measurement - ADC 16

Post any questions about our parallel port products

Conductivity measurement - ADC 16

Postby Ateka11 » Fri Jan 14, 2011 8:18 am

Hi, I have recently purchased an ADC 16 and the terminal board to measure temperature and conductivity (in siemens)
There are 2 conductivity probes connected in series- 1 for voltage and 1 for current.
The measuring signal must be AC to prevent salt build up on the electrodes and temperature compensated.
Question: Does anyone have a circuit diagram for this and the formula.
Thanks in advance for any assistance :)

Return to Parallel Port Products

Who is online

Users browsing this forum: No registered users and 0 guests