Test and Measurement Forum

Pico 2203-AWG Signal Out to perform probe compensation?

Post any questions you may have about our current range of oscilloscopes

Pico 2203-AWG Signal Out to perform probe compensation?

Postby pjphilp0325 » Sat Jun 13, 2009 1:38 am

Is it possible to perform probe "compensation adjustmet" using the method described in the probe "manual" by using the AWG and Signal Out on the 2203? The scopes I use at work all have the "cal" lug for doing this.

Related question - can I use the AWG functionality on Signal Out to feed a signal to ChanA or ChanB of the 2203? I was thinking that it would make a decent "learning tool" for the PicoScope6 software if I could generate a certain type of signal using the AWG and then learn how to set up the software to optimize sampling of that type of signal.
pjphilp0325
Newbie
 
Posts: 1
Joined: Sat Jun 13, 2009 1:20 am
Location: Dallas, TX, USA

Postby ziko » Mon Jun 15, 2009 7:57 am

Hi if you use a 1kHz square wave on the signal generator then you can do this.

To answer your second question then you can use a BNC to BNC cable from the sig gen output to either channel A or B. You can then perhaps use a sweep and add a frequency measurement to show that the frequency is changing.

You can adjust the number of samples which will affect the sampling rate.

Hope this helps.
Ziko

Technical Specialist
ziko
Zen Master
Zen Master
 
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots


Return to USB PC Oscilloscopes

Who is online

Users browsing this forum: No registered users and 0 guests