Triggered issues about pico scope5444

Post your .Net discussions here
Post Reply
aiqi
Newbie
Posts: 0
Joined: Tue Dec 26, 2023 9:06 am

Triggered issues about pico scope5444

Post by aiqi »

When I use Rapid block mode. I have set numRapidCaptures to 1000.But it didn't work.All received numbers are 0.At this point, the trigger channel frequency is 100khz.Then I set the frequency to 1Mhz.it work.

Then I tried and when the trigger frequency was 100Hz, I couldn't even receive a waveform.All received numbers are 0.

I think this may be a triggering issue.

I want to know how to set numRapidCaptures as much as possible，at low frequencies。And not receiving 0 anymore.
Top
Post Reply

Return to “.Net Languages (C#, VB.Net, .)”