Bug rising edge count and High / low pulse widht

bennog · Post by **bennog** » Sat Nov 04, 2023 4:30 pm

When you have more than about 20000 rising edges in a single waveform buffer then the rising edge count and high / low pulse width functions stop working.

While testing a encoder divider / multiplier I noticed these measurements stop working.
I was investigate if it was smart division or only counting encoder divider.

File was too big for attachment so made a link.
https://www.ans-net.nl/picotech/2023110 ... aph.psdata

P.S. zooming and panning is also very slow in this psdata file due the amount of samples in a single capture.

Benno

Post by **Gerry** » Wed Nov 22, 2023 2:23 pm

Hi Benno,

I apologise for the delay in getting to this post.

I can confirm that I replicated this. Could you send a support request to our help desk at support@picotech.com (and add FAO Gerry in the title), so that I can link it to a bug fix request for our development team.

Regards,

Gerry

bennog · Post by **bennog** » Wed Nov 22, 2023 2:32 pm

ok done.

Benno

Test & Measurement Forum

Bug rising edge count and High / low pulse widht

Bug rising edge count and High / low pulse widht

Re: Bug rising edge count and High / low pulse widht

Re: Bug rising edge count and High / low pulse widht