PicoScope 7 Software
Available on Windows, Mac and Linux
Channel coupling sticks on DC
Channel coupling sticks on DC
Hi i recently bought a PICO2204A to help with diagnosis of faults on an old 1930's Radio i'm not sure if i inadvertently damaged one of the inputs when i was probing some high voltage signals.
the fault is only on channel B and wont switch to AC coupling. the display remains as if it is DC coupled.
this means i cant see the RF signal which is considerably smaller than the DC Bus voltage.
any help please
the fault is only on channel B and wont switch to AC coupling. the display remains as if it is DC coupled.
this means i cant see the RF signal which is considerably smaller than the DC Bus voltage.
any help please
Re: Channel coupling sticks on DC
Hi Andy,
Send a support request into our Help Desk at support@picotech.com. We can then start a returns procedure to get your device into the hands of our Test and Repair Team. If your device is no longer under warranty, we can give you a quote for the cost of the repair.
Regards,
Gerry
Send a support request into our Help Desk at support@picotech.com. We can then start a returns procedure to get your device into the hands of our Test and Repair Team. If your device is no longer under warranty, we can give you a quote for the cost of the repair.
Regards,
Gerry
Gerry
Technical Specialist
Technical Specialist
Re: Channel coupling sticks on DC
Thanks Gerry