PicoScope 7 Software
Available on Windows, Mac and Linux
Time-delay on trigger
-
philippe78
- Newbie
- Posts: 0
- Joined: Tue Jul 11, 2023 10:01 am
Time-delay on trigger
I can't find the time-delay function of the Picoscope 6 on the Picoscope 7.
I use it for level measurement because I have a big difference of time between signal position on channel B and trigger on channel A(few ms) and signal length (few µs).
On Picoscope 7, I only find a pre-trigger function on % (I will need post trigger in time as it was available on Picospcope 6).
I also try to use Math channels but I see no impact of advance when I change value and delay can only be set in seconds (I can put B[-1] but not B[-0.001])
I use it for level measurement because I have a big difference of time between signal position on channel B and trigger on channel A(few ms) and signal length (few µs).
On Picoscope 7, I only find a pre-trigger function on % (I will need post trigger in time as it was available on Picospcope 6).
I also try to use Math channels but I see no impact of advance when I change value and delay can only be set in seconds (I can put B[-1] but not B[-0.001])
Re: Time-delay on trigger
Hi Philippe,
I'm responding to this quite late, but if this was not resolved for you, then the answer is that you need to select one of the advanced Trigger types to access the delay option.
Regards,
Gerry
I'm responding to this quite late, but if this was not resolved for you, then the answer is that you need to select one of the advanced Trigger types to access the delay option.
Regards,
Gerry
Gerry
Technical Specialist
Technical Specialist