PicoVNA 5 Software Bugs

Discussions forum for our Sampling Oscilloscopes, VNA, and Pulse Generators
Post Reply
Shape1185
Newbie
Posts: 0
Joined: Fri Jun 23, 2023 1:55 pm

PicoVNA 5 Software Bugs

Post by Shape1185 »

There are a few issues preventing me from using my PicoVNA 106 hardware with the PicoVNA 5.2.4 software. I have an SOLT-STD-F calibration kit.
  1. When performing a calibration, I'm unable to set the start frequency to any value lower than 10 MHz. I would expect to be able to calibrate down to the minimum frequency of the VNA which is 300 kHz.
  2. I have been using my calibration kit with the 2-port non-insertable DUT (SOLU) mode of calibration. I am able to get through all calibration steps fine but as soon as I go to apply the calibration, the software crashes. This is preventing me from using the software since I cannot calibrate my VNA. See the attached picture for the error.
Attachments
Screenshot 2023-06-23 094946.png
Top
Martyn
Site Admin
Site Admin
Posts: 4501
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: PicoVNA 5 Software Bugs

Post by Martyn »

Can you please email support@picotech.com with additional details of your PC setup and the calibration modes you are using, we can then put you in touch with the RF team to work through these issues
Martyn
Technical Support Manager
Top
Post Reply

Return to “RF Products”