Intelligent Probe Interface specification request (for 9404 series)

JeremyM · Post by **JeremyM** » Sat Dec 18, 2021 6:29 am

Is there a specification for the 6-position connector on the front of the scopes? I'd like to make some impedance converters/buffers to use 1MOhm type probes on a couple of channels, and if I can leverage the power supplies and/or signal information about the probe, that would be useful.

Post by **Gerry** » Wed Dec 22, 2021 1:35 pm

Hi Jeremy,

If this is for a personal application, then I'm not sure that we would divulge that information. If its for a commercial product you would need to speak to our RF Business Manager. In either case, you can find out more by contacting our help desk, in the first instance, with an email addressed to support@picotech.com stating what this for.

Regards,

Gerry

JeremyM · Post by **JeremyM** » Sat Dec 25, 2021 6:40 pm

Thanks!

Test & Measurement Forum

Intelligent Probe Interface specification request (for 9404 series)

Intelligent Probe Interface specification request (for 9404 series)

Re: Intelligent Probe Interface specification request (for 9404 series)

Re: Intelligent Probe Interface specification request (for 9404 series)