PicoScope 7 Software
Available on Windows, Mac and Linux
1-Wire Decode in Overdrive Mode
1-Wire Decode in Overdrive Mode
I cannot get PicoScope to decode my 1-Wire signals when they go into Overdrive mode. Standard Speed mode decodes ok.
My settings for the Overdrive mode are: Threshold:1V, Hysteresis:100mV, Sample Time From Falling Edge:3uS.
When 1-Wire messaging begins, it starts in the Standard speed mode and negotiates moving up to the Overdrive mode. When I trigger then wait the appropriate time until the Overdrive communication starts there is no decoded signals shown. I have tried a variety of settings with no luck.
Has anyone seen this work??
-DD
My settings for the Overdrive mode are: Threshold:1V, Hysteresis:100mV, Sample Time From Falling Edge:3uS.
When 1-Wire messaging begins, it starts in the Standard speed mode and negotiates moving up to the Overdrive mode. When I trigger then wait the appropriate time until the Overdrive communication starts there is no decoded signals shown. I have tried a variety of settings with no luck.
Has anyone seen this work??
-DD
Re: 1-Wire Decode in Overdrive Mode
can you post a psdata file of this ?
Benno
Benno