The first data collection run is fine.
Subsequent collection runs, however, are wrong. They start with values in the thousands of counts and fade to 0.
If I close the scope and re-open it, then the first data collection is correct again.
This leads me to suspect I am missing a step in the set-up of a new run.
Can you advise, please?
Thanks.
Regards,
Andy
-------------------------------------------
An update:
An update on this – I switched from using the simple trigger to using the full trigger call (i.e. set Conditions, set Directions, set Properties, set Delay) and the scope now immediately returns results. Values are centred around 0.