Kindly ask for your reply, thanks!
About slope trigger
About slope trigger
I don’t see the slope trigger function in picoscope 6, but I want to know if it can be replaced by other trigger methods already available in picoscope 6?
Kindly ask for your reply, thanks!
Kindly ask for your reply, thanks!
Re: About slope trigger
Slope trigger is an edge trigger where you specify either Rising or Falling Edge, so the default trigger mode of a PicoScope.
Martyn
Technical Support Manager
Technical Support Manager
Re: About slope trigger
Thank you Martyn!
My statement may not make you understand, what I mean is the following trigger mode, this trigger is based on the time between two voltage thresholds. It is not a simple edge trigger, I think.
My statement may not make you understand, what I mean is the following trigger mode, this trigger is based on the time between two voltage thresholds. It is not a simple edge trigger, I think.
- Attachments
-
Re: About slope trigger
We don't have that specific trigger but may have other triggers that can catch the same signal conditions, but without knowing what you are looking to do it would be difficult to say.
Martyn
Technical Support Manager
Technical Support Manager