PicoScope 7 Software
Available on Windows, Mac and Linux
Pico Scope 2000 signal generator is not applying offset
-
danielbf109g
- Newbie
- Posts: 0
- Joined: Sun Mar 08, 2020 7:16 pm
Pico Scope 2000 signal generator is not applying offset
I'm trying to generate a square periodic signal that goes from 0V to 1V. I select Amplitude = 500 mV and Offset = 1V.
In the moment I apply these changes, I can see the square signal correctly (from 0V to 1V) but rapidly it goes down to -0.5 ~ 0.5 Volts again.
What should I do?
In the moment I apply these changes, I can see the square signal correctly (from 0V to 1V) but rapidly it goes down to -0.5 ~ 0.5 Volts again.
What should I do?
Re: Pico Scope 2000 signal generator is not applying offset
Are you feeding the signal from the generator back into a channel ?
If yes is the Channel DC or AC coupled ? AC coupling would cause the signal to initially show correctly then drift back so that there is no offset.
If you still have issues then a psdata file showing your setup would help.
If yes is the Channel DC or AC coupled ? AC coupling would cause the signal to initially show correctly then drift back so that there is no offset.
If you still have issues then a psdata file showing your setup would help.
Martyn
Technical Support Manager
Technical Support Manager