status["SetSigGenBuiltIn"] = ps.ps2000aSetSigGenBuiltIn(chandle, 0, 2000000, wavetype, 10000, 10000, 0, 1, sweepType, 0, 0, 0, triggertype, triggerSource, 1)
assert_pico_ok(status["SetSigGenBuiltIn"])
# Pauses the script to show signal
time.sleep(10)
hello all,
I am using picoscope from 2000a series. I am writing a pyton script that can produce a sound for limited time,
for this use i found this sweeping function which can sweep on frequency range, according to some variables.
The problem is that when it gets to the end of this range it will not stop by himself, it will remain on the last frequency until new order will come (close unit, new sweeprange). which will be after the sleeping will be completed.
I need a way to make it stop producing output. This feature is very important for me! is there any function that will silent the Picoscope's output?
I had work on it awhile, and found out more technical problems.
I am working with 2206BMSO,
I need to write python script which jump between two frequencies every 1/(2*f) seconds.
from my checking the device is not switching fast enough when I checking it in the following code.
assume that sleep is not the problem since i implemented it later with while loop that wait for the time to pass.