PicoScope calibration

Post any questions you may have about our current range of oscilloscopes
Post Reply
dstrehlow
Newbie
Posts: 0
Joined: Wed Oct 17, 2018 7:07 pm

PicoScope calibration

Post by dstrehlow » Wed Oct 17, 2018 7:31 pm

Other than performing "Zero Channel Offsets" and rescaling channels for actual value, is there a way to "reprogram" a PicoScope for nominal readings if any fail accuracy verification?
If so, is this capability held solely by Pico Technologies or is it available for distribution?

Thank you for any information available.
Dennis

Martyn
Site Admin
Site Admin
Posts: 3467
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: PicoScope calibration

Post by Martyn » Thu Oct 18, 2018 5:20 am

If units are outside specification they would need to come back to the factory.
Martyn
Technical Support Manager

Moonwalker
Newbie
Posts: 0
Joined: Tue Feb 11, 2014 6:36 pm

Re: PicoScope calibration

Post by Moonwalker » Tue Dec 18, 2018 11:21 pm

I have the 5244B. Connecting probes to ground one channel is reading 6mV and the other channel reading 35mV. Does the scope need calibration? If yes do you have a local agent in Malta please?

Post Reply