Trigger of Signal Generator on 5444A

Post your LabVIEW discussions here
Post Reply
Shogo
Newbie
Posts: 0
Joined: Tue Aug 02, 2016 9:57 am

Trigger of Signal Generator on 5444A

Post by Shogo » Mon Dec 18, 2017 8:06 am

I am using 5444A. Is it possible to generate pulses synchronized to the data aquisition trigger that is taken from ch A?
Although I have tried "PicoScope5000aAWG.vi", pulses from signal generator were not synchronized to the scope trigger no matter what "Trigger Source" was selected.

Hitesh
Site Admin
Site Admin
Posts: 2829
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire

Re: Trigger of Signal Generator on 5444A

Post by Hitesh » Mon Dec 18, 2017 9:33 am

Hi Shogo,

You may wish to refer to this document.

You can set the signal generator to output a defined a number of cycles of a waveform or start sweeping between two frequencies on a trigger event, including when a trigger condition is met on the scope input channels.

What parameters have you set on the call to the library function?

Regards,
Hitesh

Technical Support Engineer

Post Reply