Test and Measurement Forum

about signal generator

Post discussions on applications you are writing

about signal generator

Postby shijinquan » Wed Aug 30, 2017 9:26 pm

Hello,

I am using the picoscope 2206 for my tests and and I am facing a problem. When I connect the scope with my computer and open the software then click the signal on, however, signal can not be changed and the signal can not control the signal. But when I use the Demo model, everything goes well. Anyone knows the reason? Is there a problem with my picoscope?

Thanks
shijinquan
Newbie
 
Posts: 0
Joined: Wed Aug 30, 2017 9:20 pm

Re: about signal generator

Postby Martyn » Thu Aug 31, 2017 5:41 am

Have you connected the output of the signal generator to the input Channel A using a BNC cable or scope probe, probe tip into the AWG connector BNC end on Channel A
Martyn
Technical Support Manager
Martyn
Site Admin
Site Admin
 
Posts: 2787
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots


Return to Applications

Who is online

Users browsing this forum: No registered users and 0 guests