adc200/20 usb-pp1 problem in labview

dear pico
please let us know how to declare usb port as 101 in labview adc200vi example. There is no option for usb port. there are only four options none, lpt1, lpt2 & lpt3 . also if we use parralel port lpt1 using parallel port then adc200vi example run for one time only. on running it second time it does not open port lpt1 "& output vale 0 only. we have to shut the labview 8.2b23 to make the vi run again. please help as we are stuck with only adc200/12 device without any use. We have pico make parallel to usb adapter. Pcoscope runs ok with usb adapter. VB example works fine with usb port. What we have to develop programme in labview only.please reply.

Ravi

Hi and thank you for your post.

Currently we are running a limited service over the Christmas period and as such I cannot answer any programming questions. However we will be operating fully from next week.

Sorry for any inconvenience.

Kind regards

Ravi,

Attached is a revised vi for the ADC-200 with the USB Parallel Port adapter available as an option...

Regards,

Richard Boyd
Crag Technologies, Inc
http://www.pc-oscilloscopes.com