I am trying to set upp an automatic logging function.
I have an ADC-200/100 and it should be waiting for
a trigg event (1V) to occure and then make a 20 sec
long sampling and write this to a file. After this it
shall start again and wait for a trigg event.
I have tried to set it up but I can not get this to work.
This is how I have been doing:
Recording: Fast block, Repeat immediately
ADC200 Block: Time base=655Î¼s, Samples=30000
Trigger: Enable, Rising, Thresh=1V
This is working for one trigg event then it will carry
on immediately without waiting for a trigg event.
How shall I make a setting so it will wait for next trigg event?