TC-08 & pressure transducers
TC-08 & pressure transducers
What is the least expensive/easiest method to log water pressure using a TC-08? The pressure is in the range of +/- 5 psi and the water is flowing in a 1" line. Adapting fittings and brazing inlets aren't a problem.
Re: TC-08 & pressure transducers
Please contact support@picotech.com to discuss the requirements in more detail. Specifically we would require information on any pressure sensors that you would like to use.
Martyn
Technical Support Manager
Technical Support Manager
Re: TC-08 & pressure transducers
Thanks - will do!
-
- Newbie
- Posts: 0
- Joined: Sat Mar 11, 2017 9:47 pm
Re: TC-08 & pressure transducers
Hello drastus and Pico team.
What was the result of this inquiry? Can either of you post some basic details about the solution to measure pressure with the TC08? Which pressure sensor did you end up using and were there any modifications to the circuit needed to scale the voltage or amperage?
Thank you,
Ben Jordan
What was the result of this inquiry? Can either of you post some basic details about the solution to measure pressure with the TC08? Which pressure sensor did you end up using and were there any modifications to the circuit needed to scale the voltage or amperage?
Thank you,
Ben Jordan
Re: TC-08 & pressure transducers
The simplest method would be to use the Single Channel Terminal Board and a 4 to 20mA pressure sensor that fits with your requirements.
Martyn
Technical Support Manager
Technical Support Manager