I cant get the pulse width trigger to work. The signal is about 12khz square wave @ 5V.
Pulse direction = Pos or Neg
condition = Greater than
Threshold 2V
Hysteresis = 0
I can't get the scope to trigger id the time is greater than 0s. ( At 0s it triggers all the time.)
Correction! The scaling now also works with the triggering! So that might not be your problem! I know older versions of PicoScope did not scale the trigger values. Are the settings you created from an older version of the software or did you create them from scratch?
The settings are created from scratch. The trigger point looks to be in the correct place. If I adjust the time to 0 seconds the waveform triggers, but anything larger than that (like 300ns) then it doesn't.
This is the waveform triggering from CHB, so it should trigger: http://i.imgur.com/3bD8EBa.png. Is there a reason why this wouldn't work with pulse width triggering?
The pulse width should work, we both tried it so your problem is a bit of a strange one! What I would say is try reset the start up settings and then load the start up settings and then reconfigure your settings. Let me know how you get on.
AHAAAAAAAAAA! I figured out the problem! I was using a 2205, not a 2205MSO! I can recreate your problem on 6.50.3, however the latest beta version and the latest standard version seem to work. So 6.6.57.18 and beta 6.7.15. 6.6.57 can be found on the normal download whilst the beta can be found in the following link: