Hi Martyn, are there any news with this issue? My old PC has just died so I actually install a new one - and I again have to install some very old version because of this issue with the math channels. It's really annoying!! You have done so much good work making the software better and better - and ...

I'll try this - thanks a lot!

Hi again,
can you tell me the Picoscope version number, at which the change of ranges of channels with math channels was disabled? I'd like to switch to a newer version, but not to one with no possibility to adapt the ranges.
Thank you!

Thanks for your reply. So I'll have to switch back to an older version... ;o)

I have an add-on:
I have checked my old setup (3204 scope with Picoscope 6.6.16.12) - here the tick is saved as I ticked it - consequently it workes right.
So it seems that it is a problem of Picoscope 6.12.9 - shall I just try the actual version?

Hi Martyn, thanks for your fast reply. Yes - the scope is running and working. Because of your request for a video I simplified my channel configuration and partly tracked down the problem: It only occurs at math channels. The pure input channels (which I didn't use on the screen...) do react normal...

Hi, I have a strange problem with a combination of a 6403 Scope with Picoscope 6.12.9.2917 (PC: Win 7 notebook with i5-4200 processor, 4 GB RAM) When I change the input range for adapting it to the max. voltage I actually feed into the scope, then the y-Axis of the scope does not follow this new ran...

Hi,
thanks for these fast replies - I just tried the maths channels and it seems to work perfectly - even with a saved bunch of waveforms - thanks a lot !
And btw. I use Picotech 6.6.16.12 with a picoscope 6403.
Best regards
Martin

Hi, my question is: Is it possible to calculate/produce an averaged recording from a bunch of buffered single signal recordings ? Background: I have to record signals with short pulses, which are slightly different each triggered and recorded "shot". Until recently I used persistance mode to see an ...