Where it says"Auto" next to the channel letter in the top bar you can set the voltage range which, when divided by 10, gives you volts per div. Is that the adjustment you meant? Yes, I saw that control, but this seems to be the scope's input scaling amplifier control. For example, say you have a 50...

Which particular functionality would you be looking for BlockMode/StreamingMode? With a SimpleTrigger? Using the Signal Generator? The sample waveform shown below represents a 48VDC/20A switching power supply, operating with a switched 20A load at 50Hz, 10% Duty Cycle. As seen, manually setup scope...

Just an observation, but OK folks, I've been using scopes since the stone age (and probably being a little nit picky), but I've never seen a scope without "V/div" (volts per division) controls. I'm currently evaluating PicoScope 6 (using the 3404A), and that control just seems to be missing. Now, I ...

There are two device ranges here, the 3000 series which is no longer made, and the new 3000a series which is in current production. There were VB examples for the old 3000 series devices, we were still actively using VB6 when these products were developed, and these can still be found by downloadin...

Hello all, I'm new to PicoScope, and specifically to the PS 3404B, in fact, I don't even have the scope yet in hand. What I need are programming examples in VB/VB6 (even VBA), At this point, anything will help. Specifically, I need to measure a current and voltage waveforms for an automotive control...