Test and Measurement Forum

Method of Measuring 20-bits of CAN message

Post any questions you may have about our current range of oscilloscopes

Method of Measuring 20-bits of CAN message

Postby SamSensata » Tue Jan 24, 2017 6:18 pm

Hi Guys,

In my current job role I'm setting up a test which involves the measurement of the time scale of 20-bits of a CAN frame. This must be done 100 times for each DUT and must be done across three temperature ranges (meaning manual testing involves around 600 measurements lol).

I was hoping I could use my pico scope (500 series) and set it up to decode for a specific CAN frame ID, measure the total pulse width taken by 20-bits and set this up to run automatically.

I'm clutching at straws, but have turned to this forum to see if anyone has any idea if/how this could be done.

I've been playing around with my pico scope and I don't see a direct or simplistic method of achieving this.

Posts: 0
Joined: Tue Jan 24, 2017 6:10 pm

Re: Method of Measuring 20-bits of CAN message

Postby Martyn » Mon Jan 30, 2017 10:35 am

If you can create a trigger that will reliably pick up the 20 bit can packet on the display, then using the mask feature to would allow you to see if this goes outside limits.

Unfortunately it is not possible to trigger on specific CAN data, so setting up the trigger may be the difficult part.
Technical Support Manager
Site Admin
Site Admin
Posts: 2908
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Return to USB PC Oscilloscopes

Who is online

Users browsing this forum: No registered users and 0 guests