I have used the ADC-11 with a laptops running Windows 2000 and a Quatech SPP-100 PCMCIA to Parallel port adapter with no problems. I have tried several times to run this same configuration with Windows XP and can not make it work. The error is the same cannot find pico.sys V4.3. Do you have any ideas?
I am currently using PicoLog for Windows Version 5.14.6 but I have used Version 5.04.7 for a few of years. When I switch to Windows XP and got the error I up graded my PicoLog S/W to the latest version on your web site.
The error occurs during set up of the logger under converter details, when I select ADC-11 (Parallel Port) and Port LPT1 and click OK the Device status dialog box appears with the following:
ADC11/22 Driver V4.3
pico.sys not found
I am not sure of the mode selection details but I do have the adapter set up as LPT1, use no interrupts, and legacy plug & play enabled with the latest drivers installed from the adapter manufacturer.
I would recommend downloading our latest software. I would also remove the old software completely before re-installing the new one. Let me know how you get on.
Hi,
I am currently experiencing the same problem as Ziko, my OS is windows XP. At startup, the voltage signal is always zero and when i try to change the converter, an error pops up saying
ADC11/22 Driver V4.3
pico.sys not found
I have already tried uninstalling and installing the laster driver. Still the same result. In the past month, the equipment was working well till last week when somedays it was okay, somedays it showed the error above. Recently, the error have been more frequent.