I wonder if anyone can help me figure this problem out, I have attached below an example of a bridged amplifier & the problem I can foresee is in actually connecting the Picoscope to the output of the amplifier in order to perform the usual measurements.
With a regular amplifier the speaker output consists of an output & ground, so connecting the Pico to this is very easy. The problem I can see with testing a bridged amplifier is that as soon as I connect the Pico to the output, it looks like to me that this will effectively short the negative output of the amplifier down to ground.
Either use a differential probe/ scope, otherwise use two channels, one for positive and one negative, and then select a maths channel to display the difference. Please ensure that you are operating within the acceptable ranges for the scope, and applying any necessary safety measures.
I have never measured a bridged amp before so I have only ever used one channel, the maths channels are something I have not really used either & I noticed there are quite a few to select, which one would I use for this arrangement?
One final question, I use the 4262 for measuring THD, so if I used this method of connecting to the bridged amp using a maths channel, would the usual automated measurements still work & be just as accurate as when using a single channel?
You would need to use A-B or B-A depending upon which is the positive signal.
When using maths channels the number of samples collected is reduced to 2MS per waveform, using the release version of the software, although this has been increased to 5MS in the beta version. This may have an effect on the measurements you are taking, but this will depend upon the settings you are using.