I using PicoScope 5.11.8 with ADC212/50 in X-Y mode and I want to move the figure both up-down and right-left in the same mode like in a analogue scope using "position" knobs.
Is it possible?
You should be able to do this by selecting the x1 zoom for both axis. This then gives you scroll bars on the side which you can use to posistion the figure.
I know the x1 zoom tool for both axis, but when I move the figure , the scale of each axis move too. So I need move only the figure and keep the scale fixed.
Best Regards
Ariel
Sarah wrote:Hi Ariel
Thank you for your post.
You should be able to do this by selecting the x1 zoom for both axis. This then gives you scroll bars on the side which you can use to posistion the figure.
I do not believe this is possible as if you just move the figure then the readings against the axis will not be correct. Therefore the axis moves with the figure. I do not know of any other way to do this in Picoscope.
Sorry, but if you choose any scope (analogue or digital), you can do this. You can move the figure while the scale is static. I know that the "absolute" readings will not be correct, but you can use the cursors to perform relative measures.
On the other hand, I think that I can use the offset null tool to make a little adjust of channels.
So, I would like you take in mind this subject for next upgrade.
Best Regards,
Ariel
Sarah wrote:Hi
Thank you for your post.
I do not believe this is possible as if you just move the figure then the readings against the axis will not be correct. Therefore the axis moves with the figure. I do not know of any other way to do this in Picoscope.