Hello:
I want to design a 1GS/s-speed data acquisition system based on Labview to drive PicoScope 5203 PC oscilloscope using PS5000.dll.
interface driven design use the function of int32_t _ps5000OpenUnit@4(int16_t *handle).
sampling-data control use the function of int32_t _ps5000GetTimebase@28(int16_t handle, uint32_t timebase, int32_t noSamples, int32_t *timeIntervalNanoseconds, int16_t oversample, int32_t *maxSamples, uint16_t segmentIndex)。
we can get a sampling rate of 500MS/s.but,when we chang the sampling rate of 500MS/s to 1GS/s,the Labview can not run.
I need some help.
thank you very much.
ziko wrote:By default both channels are enabled, you will need to disable chB this is why your sample rate is only half.
Kind regards
I,m grateful for your quick response.
I set "int32_t channel"in the function of setup Channel B from 1 to 0 ,chB is disabled.but the labview still can not run on the sampling rate of 1GS/s
Hi there,
I also use the same picoscope for data acquisition. Before I installed winXp 32 in my PC. Now I used windows 7 64. It works for me after trying several time...