PicoScope 7 Software
Available on Windows, Mac and Linux
There is no specific function when using RapidBlock or Block modes however you may be able to use the Trigger Time Offset functions and if these return sensible values then a trigger would have occurred.Is it still the case that the pico driver does not indicate whether a given capture was acquired from an actual trigger level being detected versus auto-triggering after a set delay (in the absence of the trigger condition)?
It's not a case of no capture will be done, the trigger will still be armed and the scope will be waiting indefinitely for a trigger.What happens to a given data capture if I set the auto-trigger delay to 0ms and no trigger level is detected: No capture is done, and the digitizer re-arm the trigger for the next capture?