I am using the PicoScope 6.0.13 together with PicoScope 5204.
I am using the supplied 250MHz passive prove & I set the attenuation to x10. At the same time, I also set the "Probe Setting" to x10, so I get exactly what I input into the probe tip.
I then set the trigger to "Rising Edge Trigger".
I do not notice this problem since most of the time, the trigger level is set to 0V. Until this afternoon, I want to trigger to a level other than 0V, I notice that the trigger level do not match my probe setting.
See attachment.
When the probe is set to x10, I wish to trigger at 800mV. As I move the "Trigger Diamond" to 800mV level, the trigger level shows at the bottom of the screen actually indicate 80mV.
I can't figure out a way to make the trigger level follow my probe setting in this case.
The threshold displayed on the trigger toolbar is the threshold set after your x10 probe has been applied.
When you drop your trigger point onto the scope at 800mV, the inverse of the probe scaling is applied and the scope is configured to trigger at 80mV. It is easy to imagine a probe that could have more than one solution to its inverse scaling; a modulus probe for example. If you were to drop your trigger diamond at 800mV the scope will need to be configured to trigger at both 80mV and -80mV.
Obviously the scope cannot be triggered at more than one threshold and so PicoScope displays the uncaled value to avoid confusion.
Thank you for your reply. I tried with PicoScope 5.20.1 (with PicoScope 3204) and here is the screen shot.
When I set the probe to x10, & place the "Trigger diamond" to 800mV level, the botton screen shows 800mV (scaled). However, the vertical range at the top of the screen says +/-200mV (Un-scaled).
You are quite correct. PicoScope 6 does behave differently to PicoScope 5 in this instance. PicoScope 5 cannot create custom probes and as such does not suffer from the problem that I described in my earlier post.
How would you 'fix' this problem for the modulus probe that I described earlier?
The scope cannot trigger at more than one threshold. It would be even more confusing to have different behaviour for probes that have multiple solutions to their inverse scaling.
- the trigger threshold level, which displayed at the bottom left of the screen, should always match the vertical scale of the selected trigger source channel.
I understand that the PicoScope 6 allow user to define their custom probe with custom unit, mx+c scalling. If I want to trigger at a specific level of my custom probe (with my custom unit), I should be able to define them easily with the trigger toolbar as well as the "trigger diamond".
Actually, I don't quite understand about the "Modulus Probe" you've mention about, I've never seen any of those.