Test and Measurement Forum

PicoScope 4444

Which product is right for your exact requirements

PicoScope 4444

Postby wally555 » Thu Nov 30, 2017 2:10 am

I have been looking around for a scope to use for SMPS development. The 4444 with its high vertical bit count and isolated channels looks interesting. But it's fatal flaw is no AWG. For SMPS work i would need to be able to make bode plots and check component impedance at a range of frequencies.

The open source software here looks very good.
topic14311-90.html

But with no AWG on the 4444 there is no solution. I think you should redesign the 4444 with a good quality 20 MHz AWG for bode plots and audio work.

Thank you.
Wally
wally555
Newbie
 
Posts: 1
Joined: Thu Nov 30, 2017 1:52 am

Re: PicoScope 4444

Postby Hitesh » Thu Nov 30, 2017 9:36 am

Hi Wally,

The PicoScope 4444 has a set of calibration pins which can be controlled using the API functions but the waveforms that can be output are limited in terms of the type and frequency range.

I have raised a new feature request. In the meantime, you could use a PicoScope 5000 Series oscilloscope with active differential probes to provide the isolation. These PicoScope models can be used with the Frequency Response Analyzer.

Regards,
Hitesh

Technical Support Engineer
Hitesh
Site Admin
Site Admin
 
Posts: 2791
Joined: Tue May 31, 2011 3:43 pm
Location: St. Neots, Cambridgeshire


Return to Pre-Sales Advice

Who is online

Users browsing this forum: No registered users and 4 guests