High Voltage, too high

Post any questions you may have about our current range of oscilloscopes
Post Reply
Posts: 0
Joined: Thu Dec 16, 2010 4:48 pm

High Voltage, too high

Post by boda77 »

Hi, picoscope 3205

I believe I might have plugged in a signal with a higher voltage than the 20V limit. Since than when I start the picoscope 6 software, for that channel, i get a red exclamation markl near the top and am unable to see any signals.

How best to go about fixing it?


Advanced User
Advanced User
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Re: High Voltage, too high

Post by ziko »

Hi yes this does look like a voltage overload, the unit would need to be sent back to us for repairs.

Please email support@picotech.com

Kind regards

Technical Specialist

Post Reply