PicoScope 7 Software
Available on Windows, Mac and Linux
Serial TC-08 didn't record any data
-
Guest
Serial TC-08 didn't record any data
Hi there
Since my old PC is not working well, i downloaded the software and re-installed it to a new PC. Even though i installed it step by step, i can't use it. Do i need the old data to copy and paste to the new PC? It's urgent now. If it can't go well, i may need to stop the manufacturing. SERIOUSLY!!
Best regards,
Sandy
Since my old PC is not working well, i downloaded the software and re-installed it to a new PC. Even though i installed it step by step, i can't use it. Do i need the old data to copy and paste to the new PC? It's urgent now. If it can't go well, i may need to stop the manufacturing. SERIOUSLY!!
Best regards,
Sandy
Sandy,
What errors/issues are you running into?
Regards,
Richard Boyd
Crag Technologies, Inc
http://www.pc-oscilloscopes.com
What errors/issues are you running into?
Regards,
Richard Boyd
Crag Technologies, Inc
http://www.pc-oscilloscopes.com
-
Guest
Thank you so much
Hi Richard,
I'm very sorry if i cause you any inconveniences. Now it is OK. I uninstall it and then re-install it very carefully. Then it ran smoothly. I'm very sorry to give you any trouble. Anyway, i'm very appreciated your quick reply. I'm sure, in future, you can solve any problems occur in the Picolog. I'm new to that one. Thanks again!
Best regards,
Sandy
I'm very sorry if i cause you any inconveniences. Now it is OK. I uninstall it and then re-install it very carefully. Then it ran smoothly. I'm very sorry to give you any trouble. Anyway, i'm very appreciated your quick reply. I'm sure, in future, you can solve any problems occur in the Picolog. I'm new to that one. Thanks again!
Best regards,
Sandy