Hi from Geoffrey.

[Geoffrey]

Greetings,

My first PicoTech product was the ADC-42 purchased in February 2002, the best is the ADC-216 a real 16 bit device with superb resolution and a 96 dB dynamic range, without recourse to software approximation, which allowed spectral analysis of audio and other low frequency signals along with signal to noise measurements.

Now working at home I have bought a Windows 10 laptop to use with the latest PicoLog and PicoScope software. Past experience has been that PicoScope is straight forward to use but that PicoLog, which should have so many uses in the development of new products and fault finding, especially of intermittent problems, in existing devices is not intuitive.

Recent uses of the XP version have been the monitoring of voltages in a car and a television receiver for improvement of the headlights and fault finding respectively.

Best wishes, Geoffrey.

[Martyn]

Welcome to the forum.

Our current software versions are supported on Windows 10, however our older parallel port products are unlikely to work as they require a 32 bit O/S.