R5 SW with 3224 support for Advanced Triggering

Forum for discussing PicoScope (version 5)
Post Reply
Posts: 8
Joined: Wed Jan 16, 2008 4:17 pm

R5 SW with 3224 support for Advanced Triggering

Post by ffortino »

I'm using the 3224 scope with the "Save on Trigger" mode of the R5 SW.
(saving thousands of files)
I need to use the Save on Trigger, and I also need the R5 SW User Interface. I cannot use the R6 SW for my application.

Will you ever add "Advanced Triggering" to the R5 SW ?


Advanced User
Advanced User
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Post by ziko »

Hi unfortunately these features will not be added to PicoScope 5 as in the foreseeable future it will be superseded with PicoScope 6.

With PicoScope 6 you can use the waveform buffer, you can create a waveform buffer to have up to 1000 frames (under preferences). You would also have to choose Repeat as your triggering. This way every time a signal is triggered it will be saved on the waveform buffer until it fills up all 1000 frames, make sure you click on stop once you collected all your data as it will cycle round.

You can then save all your waveforms onto your computer.

Hope this helps.

Kind regards

Technical Specialist

Post Reply