differential probes
-
- Newbie
- Posts: 0
- Joined: Fri May 11, 2012 7:43 pm
differential probes
We have an GWInstek GDS-1102A oscilloscope; is there any set of differential probes that could apply to this oscilloscope? and can you supply it?
-
- Advanced User
- Posts: 2856
- Joined: Tue May 31, 2011 3:43 pm
- Location: St. Neots, Cambridgeshire
Re: differential probes
Hi Javier,
What is the peak voltage and maximum frequency of the signal that you are looking to measure? Is it mains voltage?
Please find below a link that shows the Active Differential Oscilloscope Probes that we sell:
http://www.picotech.com/oscilloscope-ac ... tml#active
Regards,
What is the peak voltage and maximum frequency of the signal that you are looking to measure? Is it mains voltage?
Please find below a link that shows the Active Differential Oscilloscope Probes that we sell:
http://www.picotech.com/oscilloscope-ac ... tml#active
Regards,
Hitesh
Software Dev. Engineer
Software Dev. Engineer
-
- Newbie
- Posts: 0
- Joined: Fri May 11, 2012 7:43 pm
Re: differential probes
We are repairing servomotors, so the peak voltage shouldn't go beyond the 500 VAC; about the frecuency I am not sure, but we will be reading the feedback signals mainly the U, V and W feedback signal comming from a motor with up to 5000 RPM with at most 4 cycles per revolution.
Hope this information will be enough for you to help us.
Best Regards,
Javier
Hope this information will be enough for you to help us.
Best Regards,
Javier
-
- Advanced User
- Posts: 2856
- Joined: Tue May 31, 2011 3:43 pm
- Location: St. Neots, Cambridgeshire
Re: differential probes
Hi,
Thanks for your reply.
If your voltage is not going above 700V, and presumably the frequency is below 25MHz, then the TA041 probe should be suitable:
http://accessories.picotech.com/active- ... html#TA041
You can purchase this direct from us or through one of our distributors:
http://www.picotech.com/distribl.html?source=HPju1
Hope this helps,
Thanks for your reply.
If your voltage is not going above 700V, and presumably the frequency is below 25MHz, then the TA041 probe should be suitable:
http://accessories.picotech.com/active- ... html#TA041
You can purchase this direct from us or through one of our distributors:
http://www.picotech.com/distribl.html?source=HPju1
Hope this helps,
Hitesh
Software Dev. Engineer
Software Dev. Engineer