need help on tc-08 usb

Forum for discussing PicoLog
Post Reply
sakarepwes
User
User
Posts: 2
Joined: Tue Mar 27, 2007 3:49 pm

need help on tc-08 usb

Post by sakarepwes »

hi, i am an engineering student
i got some difficulties in using the TC-08 (USB), this is the case:
i want to measure the temperature of an engine using a thermocouple, then i want to use the TC-08 to measure it per 1 second, then store it into a flash disk.

Is it possible?
How to do that, wihtout connecting it to a computer first?

Thank you.....

ziko
Advanced User
Advanced User
Posts: 1705
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Post by ziko »

Hi and thank you for your post.

You cannot do this, you can either use our software or write your own software, however in both cases it must be connected to a PC.

Kind regards
Ziko

Technical Specialist

sakarepwes
User
User
Posts: 2
Joined: Tue Mar 27, 2007 3:49 pm

Post by sakarepwes »

thanks for the reply..

is it still impossible to doing that, even if i connect the tc-08 into a microprocessor (stamp board), that will be connected into my flash disk on the other end?

thank you...

Post Reply