Automation with PicoScope

Post discussions on projects you are working on
Post Reply
Posts: 0
Joined: Wed Jan 04, 2017 6:03 pm

Automation with PicoScope

Post by cristina.navas »


My name is Cristina Navas. I am working with PicoScope 5444B and I need your guide with this project:
I have to measure a frecuency. If it is 32.4kHz I want PicoScope sends an alert to another program (Matlab) when this occures. PicoScope has to stop the measure after Matlab sends a signal.
In conclusion, I need to know if there is a conmmand that can send allerts from PicoScope to another software.
I appreciate your help!!!
Thank you!!!

Site Admin
Site Admin
Posts: 3872
Joined: Fri Jun 10, 2011 8:15 am
Location: St. Neots

Re: Automation with PicoScope

Post by Martyn »

There are alarms within PicoScope that can perform certain actions in response to certain events, see the Alarms section in the A to Z

However your request is very specific and would not be possible, so I would suggest handling the whole setup, collection, and processing of data directly in MATLAB
Technical Support Manager

Post Reply