I am really missing the possibility to trigger a timeout on a voltage level or window.
Example:
clock line remains low for more than 100 us should trigger, but clock line remains high should not trigger.
I tried all your trigger sources. My old Tektronix is able to do with lowpuls-greater-than-trigger. In comparison to picoscope puls trigger, the trigger occurs immediately after the time value and not at the puls' end.
The abort-Triggers are not applicable, because there is no Settings to define the edge type.
window-abort is not applicable, too.
It sounds like the Level Dropout trigger is what you require although the PicoScope 6 software does not currently give you the option to distinguish between a rising or falling condition (I will add this to an existing feature request).
With the Software Development Kit, you have a greater level of control over the trigger functionality and can then specify a Level Dropout Trigger where the device will trigger when signal goes low and stays low for greater than a specified period of time using a Pulse Width Qualifier-based trigger.
Another request for this feature ...
In my case i need to trigger when a device keeps the data line of an I2C transaction low for too long blocking the bus. Without being able to make the distinction between low/high, the level dropout trigger is useless, and i do not think i can do it with any other trigger so I have to use the old bulky scope which is a pity.
So i am hoping this feature arrives sooner than later!
I will add your comment to an existing feature request.
If you are using the Software Development Kit to control the PicoScope, then the API functions will give you a greater level of control over the trigger setup.