Forum for discussing PicoScope version 6 (non-automotive version)
-
robertmark68
- Newbie
- Posts: 0
- Joined: Mon Sep 19, 2016 7:02 pm
Post
by robertmark68 »
Hello
I have managed to save a couple of waveforms in the native PicoScope format.
I am trying to extract CSV files from these files and every time i try the csv files created are EMPTY.
Can you PLEASE assist me with this?
Robert
-
Martyn
- Site Admin
- Posts: 4491
- Joined: Fri Jun 10, 2011 8:15 am
- Location: St. Neots
Post
by Martyn »
Can you post them here and we can take a look.
Martyn
Technical Support Manager
-
robertmark68
- Newbie
- Posts: 0
- Joined: Mon Sep 19, 2016 7:02 pm
Post
by robertmark68 »
Martyn wrote:Can you post them here and we can take a look.
-
Martyn
- Site Admin
- Posts: 4491
- Joined: Fri Jun 10, 2011 8:15 am
- Location: St. Neots
Post
by Martyn »
Have you tried capturing a complete waveform, rather than a partial one, this may be the issue.
Martyn
Technical Support Manager
-
robertmark68
- Newbie
- Posts: 0
- Joined: Mon Sep 19, 2016 7:02 pm
Post
by robertmark68 »
Martyn wrote:Have you tried capturing a complete waveform, rather than a partial one, this may be the issue.
I am not at all sure what that means....
Can you elaborate?
R
-
Martyn
- Site Admin
- Posts: 4491
- Joined: Fri Jun 10, 2011 8:15 am
- Location: St. Neots
Post
by Martyn »
Your trace stops half way across the screen, wait until it has finished a full screen, and see if you can save as CSV then.
Martyn
Technical Support Manager
-
robertmark68
- Newbie
- Posts: 0
- Joined: Mon Sep 19, 2016 7:02 pm
Post
by robertmark68 »
Martyn wrote:Your trace stops half way across the screen, wait until it has finished a full screen, and see if you can save as CSV then.
Martyn
This is saved data...I no longer have access to the equipment that was the source of this measurement.
These two files are all I have....I need CSVs of the data therein.
How can we make this happen?
R
-
Martyn
- Site Admin
- Posts: 4491
- Joined: Fri Jun 10, 2011 8:15 am
- Location: St. Neots
Post
by Martyn »
Right click on the display, and select Channels and then untick AMPS, and then you can export the data.
The AMPS maths channel references a channel that is not active so the software does not know what to do for the export.
Martyn
Technical Support Manager