I am using a Picoscope, automotive version, with the Picoscope Automotive s/w. I am trying to trigger on a falling edge of a signal; however, whenever I set a trigger, the waveform disappears, and does not even trigger.
My Signal include:
1. 0-5V Pulses
2. Channels A and B
My settings include:
1. 2GS
2. Trigger: single
3. 2V at 50%
4. falling edge
5. Alarms: capture (checked)
6. Alarms: Save Current Buffer
7. Trigger on channel A
8. 20ms/div
These are the settings I have used before and it worked. However, currently, it's not even saving anymore

