Using ADC-16 to communicate with rs232 port of weighing scal

Which product is right for your exact requirements
Post Reply
akbar241

Using ADC-16 to communicate with rs232 port of weighing scal

Post by akbar241 »

I want to use suitable pico product to give me recorded graph by using RS232 serial communication port of a weighing scale indicator .Actually load cells are giving the signal to indicator and from indicator you can get digital output throgh this RS232 serial communication port.(I can not get direct signal from load cells because I want to show the net value/graph after the tare or offset weight of cotainer,which is only possible if I use the indicator RS 232 port). Is it possible through ADC-16 or you suggest any other product

Michael
Advanced User
Advanced User
Posts: 656
Joined: Thu Jul 07, 2005 12:41 pm
Location: St Neots, Cambridgeshire

Post by Michael »

Hello,

As you are bound to the RS232 port, you can use the ADC16.

This unit is commonly used for this type of application.

Best regards,
Michael
Michael - Tech Support
Pico Technology
Web Support Forum

Guest

Post by Guest »

Thank you very much for the reply.Now I want to know how/where to connect out put wires of weighing indicator RS232 port,I mean RXD, TXD and GND wires of RS232 port of indicator to which pin no. of ADC-16 input connector. Thanks again
best regards,
akbar

Post Reply