Pico TC-08 with Vee 6.0

Russ Campbell · Post by **Russ Campbell** » Thu May 05, 2005 10:07 pm

Trying to write a program with Vee 6 for use with the TC08 (Serial)
My Programmer needs either the Vee Driver for the instrement or a command set. Is there any Way we can get that?

Thank You
RCampbell
Pelco
Fresno Ca

Sarah · Post by **Sarah** » Fri May 06, 2005 9:11 am

Hi

Thank you for your post.

All of the drivers we have, including those for VEE are available at:

http://www.picotech.com/software

Hope this helps

Best Regards

Russ Campbell · Post by **Russ Campbell** » Fri May 06, 2005 2:07 pm

Thank You Sarah that should do it. If we have any other Issues we will contact you again.

Again Thanks for your Help