ADC16

Which product is right for your exact requirements
Post Reply
bjackson@nsmicrowave.com

ADC16

Post by bjackson@nsmicrowave.com »

:?: I am about to purchas 2 ADC 16 units to measure 16 channels of data on a project. How easy is it to run the 2 ADC 16s to record the 16 channels of data (via two comm ports)? I have looked at the help file of the software. It says measure in burst mode. Does that mean the software takes a burst of data from one unit then a burst of data from the other unit? If so do I have to specify how many samples make up the burst?
I await your response. :roll:

Sarah

Post by Sarah »

Hi

Thank you for your post.

Using multiple units is quite easy - when settings new settings you tick the option for "use multiple converters". You then set both of the converters up - specfiying the sampling interval and number of samples. This has to be the same for each unit. Mulitple converters can only be used in Real Time Continuous Mode.

Hope this helps

Best Regards

Post Reply